Google Translate
Brake hose information
Brake Maintenance
Technical information

Fitting alignment

In order to order a custom hose, it is recommended that you remove the original hose from your vehicle in order.

Follow these guidelines to specify hose end fittings' position in relation to each other.

  Plain & compound bend fittings will have bends or flats (sealing surfaces) facing towards each other.

The master cylinder side/pressure input side is referred to as Master end.


The caliper/receiving end of the hose is referred to as the Slave end.

 

Banjo/fittings in Zero degree state will tilt inward towards each other.
  Side bend fittings will have bends or facing towards each other.
  Plain & compound bend fittings will have bends or flats (sealing surfaces) facing towards each other.
 

In setting the angular displacement, the fitting on Master end of the hose remains static & the slave end is turned.

With the ends aligned at Zero, the Slave fitting is turned in a clockwise direction to desired angular displacement.